After built-in Portal authentication is configured on a Huawei WAC. the Portal authentication page can be displayed but Portal authentication cannot be performed. What are the possible causes?

• A.The password entered on the STA is incorrect
• B.The route configuration is incorrect. As a result, the STA cannot communicate with the built-in Portal server.
• C.The AP version is outdated.
• D.The data forwarding mode is direct forwarding, and the WAC does not allow packets from service VLANs to pass through.

Comment: *

Name: *

Email: *

Verification: *

Inter-WAC roaming and intra-WLAN roaming are supported in dual-link HSB scenarios.

• A.FALSE
• B.TRUE

Comment: *

Name: *

Email: *

Verification: *

In project deployment, the management VLAN and service VLAN of an AP can be the same. However, it is recommended that the two VLANs be configured differently.

• A.FALSE
• B.TRUE

Comment: *

Name: *

Email: *

Verification: *

Which of the fallowings is not an IPv6 address type?

• A.Multicast address
• B.Unicast address
• C.Broadcast address
• D.Anycast address

Comment: *

Name: *

Email: *

Verification: *

Which of the following encapsulation formats are used for EAP termination in 802.1X authentication? (Select All that apply)

• A.EAP-TLS
• B.EAPoL
• C.EAPoR
• D.EAP

Comment: *

Name: *

Email: *

Verification: *