You deployed a new EX Series switch with DHCP snooping enabled and you do not see any entries in the snooping databases for an interface. Which two Juniper configurations for that interface caused this issue? (Choose two.)

• A.The interface is configured as a disabled port.
• B.MAC limiting is enabled on the interface.
• C.The interface is configured as a trunk port.
• D.Dynamic ARP inspection is enabled on the interface.

Comment: *

Name: *

Email: *

Verification: *

Which statement is true about Layer 2 firewall filters on EX Series switches?

• A.They are stateless and evaluated by the forwarding plane.
• B.They are stateful and evaluated by the control plane.
• C.They are stateful and evaluated by the forwarding plane.
• D.They are stateless and evaluated by the control plane.

Comment: *

Name: *

Email: *

Verification: *

Which two statements are true about the default VLAN on Juniper switches? (Choose two.)

• A.The default VLAN is set to a VLAN ID of 1 by default
• B.The default VLAN ID is not assigned to any interface.
• C.The default VLAN ID is not visible.
• D.The default VLAN ID can be changed.

Comment: *

Name: *

Email: *

Verification: *

Which two statements about redundant trunk groups on EX Series switches are correct? (Choose two.)

• A.Redundant trunk groups load-balance traffic across two designated uplink interfaces.
• B.If the active link fails, then the secondary link automatically takes over.
• C.Layer 2 control traffic is permitted on the secondary link
• D.Redundant trunk groups must be connected to the same aggregation switch.

Comment: *

Name: *

Email: *

Verification: *

Referring to the output shown in the exhibit, which statement is correct?

• A.The state is normal for a DR neighbor.
• B.The state is normal for a DRother neighbor
• C.An MTU mismatch exists between the OSPF neighbors.
• D.An area ID mismatch exists between the OSPF neighbors

Comment: *

Name: *

Email: *

Verification: *