Your network has two ISPs available. You want to ensure that all outbound traffic is routed out ISP-1. If the connection to ISP-1 fails, all outbound traffic is routed to the backup ISP, ISP-2. In this scenario, how should you configure BGP on your network?

• A.Configure the gateway for ISP-1 with a higher peer ID than the gateway for ISP-2.
• B.Set the local-preference attribute to a higher value for ISP-2 than ISP-1.
• C.Configure the gateway for ISP-1 with a higher origin code than the gateway for ISP-2.
• D.Set the local-preference attribute to a higher value for ISP-1 than ISP-2.

Comment: *

Name: *

Email: *

Verification: *

You need to configure a LAG between your switches. In this scenario, which two statements are correct?
(Choose two.)

• A.Duplex and speed settings are not required to match on both participating devices.
• B.Duplex and speed settings are required to match on both participating devices.
• C.Member links are not required to be contiguous ports.
• D.Member links are required to be contiguous ports.

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, which configuration change is needed for an IS-IS Level 1 adjacency between R1 and R2?

• A.Configure the lo0 family ISO address 49.0002.0010.0042.0002.00 on R1
• B.Disable Level 2 on R2's ge-0/0/1 interface
• C.Configure the lo0 family ISO address 49.0002.0010.0042.0002.00 on R2
• D.Enable Level 2 on R1's ge-0/0/1 interface

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, which two statements are correct? (Choose two.)

• A.This device must be selected as the root bridge.
• B.The ge-0/0/10 interface will be part of the RSTP topology but will block incoming BPDUs.
• C.The ge-0/0/13 interface will be selected as the forwarding interface.
• D.The ge-0/0/10 interface will not participate in the RSTP topology.

Comment: *

Name: *

Email: *

Verification: *

You have configured OSPF routing as shown in the exhibit. You notice that all interfaces have formed full adjacencies, with the exception of the interfaces connecting R3 and R4 with a status of 2Way.

What is the reason for this status?

• A.DROther routers will not form a full adjacency with each other.
• B.The two routers must both be configured as DR routers.
• C.The two routers must be configured in different areas.
• D.The interface-type is not configured as p2p.

Comment: *

Name: *

Email: *

Verification: *