You enable persistent MAC learning on your Juniper switch. In this scenario, which statement is correct?

• A.You can enable persistent MAC learning on an interface where MAC learning is disabled.
• B.You can enable persistent MAC learning on an interface that is part of a redundant trunk group.
• C.You can only enable persistent MAC learning on an interface in access mode.
• D.You can only enable persistent MAC learning on an interface on which 802.1x authentication is configured.

Comment: *

Name: *

Email: *

Verification: *

You are deploying a trunk port with multiple VLANs. In this scenario, which statement is true about the native VLAN?

• A.The native VLAN is the highest tagged VLAN ID on the port.
• B.The native VLAN must be the default VLAN on the port.
• C.The native VLAN is automatically configured through DHCP.
• D.The native VLAN is an untagged VLAN ID on the port.

Comment: *

Name: *

Email: *

Verification: *

Which two statements are correct about using firewall filters on EX Series switches? (Choose two.)

• A.You can deploy only stateless firewall filters on an EX Series switch.
• B.You can only apply firewall filters to Layer 2 traffic on an EX Series switch.
• C.You can apply firewall filters to both Layer 2 and Layer 3 traffic on an EX Series switch.
• D.You can deploy both stateless and stateful firewall filters on an EX Series switch.

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

What is the management IP address of the device shown in the exhibit?

• A.10.210.20.233
• B.172.23.12.100
• C.128.0.0.1
• D.172.23.11.10

Comment: *

Name: *

Email: *

Verification: *

A host is connected to your EX Series switch using an interface with persistent MAC learning enabled. When you connect the host to another interface on the same switch, all traffic generated by the host is dropped. Which action should you perform to solve the problem?

• A.Enter the clear ethernet switching table persistent learningcommand.
• B.Configure the interface as a trunk port.
• C.Enter the clear dhcp snooping databasecommand.
• D.Disable dynamic ARP inspection.

Comment: *

Name: *

Email: *

Verification: *