Click the Exhibit button.

You recently implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communicate with the appropriate community devices connected to AS-2.
What must be done to allow these community devices to communicate?

• A.You must configure an isolation VLAN ID under the vlan-priVLAN on the AS-2 switch.
• B.You must configure the ge-0/0/1 interface on both switches as the inter-switch links.
• C.You must configure the ge-0/0/10 interface on AS-1 as the inter-switch link
• D.You must configure an isolation VLAN ID under the vlan-priVLAN on both switches.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

You have configured MSTP in your Layer 2 network. You are having problems with it establishing correctly.
Referring to the exhibit, what is causing the problem?

• A.The revision number is the same on both devices
• B.You must assign a context ID number other than zero
• C.The region name is not correct
• D.The MSTI-to-VLAN mapping does not match

Comment: *

Name: *

Email: *

Verification: *

Your network has Junos Fusion configured with MX960 routers as aggregation devices (AD) and QFX5100 switches as satellite devices (SD).
Which two statements are correct in this scenario? (Choose two.)

• A.SDs are added to the AD by configuring the cascade port on the AD.
• B.The Fusion extended ports are configured on the SDs.
• C.The AD runs the Junos software for all its connected SDs.
• D.All SDs connected to a single AD must use the same software version.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

You have configured and applied the policer shown in the exhibit to your Junos device.
Which statement is true in this scenario?

• A.Traffic exceeding the committed-information-rate will be rate limited.
• B.Traffic exceeding the committed-burst size will be marked with a loss priority of high.
• C.Traffic exceeding the committed-burst size will be discarded.
• D.Traffic exceeding the excess-burst size will be discarded.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

You are configuring BGP policies for a site with a dual-homed connection as shown in the exhibit. You must ensure that inbound traffic from Internet hosts flow through the ISP A connection.
Which statement is correct in this scenario?

• A.Apply a BGP export policy onR2to assign a lower origin value to routes advertised to ISP B
• B.Apply a BGP export policy to R2 to prepend [65001 65001 65001 65001 65001] to the AS path of routes advertised to ISP B
• C.Apply a BGP export policy on R1 to assign a higher local preference value to routes advertised to ISP A
• D.Apply a BGP export policy on R1 to assign a lower MED value to routes advertised to ISP A

Comment: *

Name: *

Email: *

Verification: *