Exhibit.

You are authenticating user devices connected to your ex Series switch. You have802.1X and MAC RADIUS configured for all ports A user is complaining about the time it takes to connect their non-802.1X device on ge-0/0/15 using MAC RADIUS authentication Referring to the exhibit, what should be done to accelerate the authentication process?

• A.Configure the no-reauthentication feature for 802.1X on ge-0/0/15
• B.Configure the restrict feature for MAC RADIUS on ge-0/0/15.
• C.Change the 802.1X retry attempts value to 5 on ge-0/0/15
• D.Change the supplicant mode to multiple on ge-0/0/15

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Referring to the exhibit, on which three IS-IS routers will the attached bit be set? (Choose three. )

• A.R6
• B.R3
• C.R4
• D.R2
• E.R5

Comment: *

Name: *

Email: *

Verification: *

Exhibit:


Referring to the exhibit, there are multiple ASM groups in the 224 0 0.0/4 range Which configuration change is needed to ensure R1 is always the RP for group 224.224.1.1?

• A.Increase the priority on R1 to higher than R2
• B.Set the priority on R1 to zero
• C.Configure R1 with a higher local RP address
• D.Ensure R1 has a more specific group range

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

Referring to the exhibit, you must advertise the 100.0.0.0/16 routes from AS1 to AS2, but R2 is not advertising any BGP routes to R5.
Why is this happening in this scenario?

• A.The IBGP routes will not be advertised because you must use a policy to advertise IBGP routes.
• B.The IBGP routes are not active and EBGP will advertise only active routes.
• C.The IBGP routes will not be advertised because the AS path shows as incomplete.
• D.The IBGP routes are not active because the next hop is not reachable.

Comment: *

Name: *

Email: *

Verification: *

You are currently using VLAN IDs 2 through 300 within your Layer 2 domain and you need to configure VSTP to prevent loops You must ensure that all VL ANs are loop free.
In this scenario, which statement is correct?

• A.You must enable RSTP to account for all VLANs.
• B.You must ensure that the VLANs are balanced between two different root bridges.
• C.You must ensure that the bridge priority is set to the lowest value on all switches in the Layer 2 domain.
• D.You must enable all VLANs, 2 through 300, under the VSTP configuration

Comment: *

Name: *

Email: *

Verification: *