You have an IPv4 multicast network configured as PIM-SM. What must be done before replacing your static RP with auto-RP?

• A.Enable sparse-dense mode on each of the routers in the network.
• B.Configure auto-RP domains on each router in the network.
• C.Configure each router in the network as a candidate BSR.
• D.Enable each router in the network to forward multicast packets.

Comment: *

Name: *

Email: *

Verification: *

There are two BGP routes to 10.200.200.0/24 received from two external peers. Route 1 comes from a neighbor with a router ID of 10.10.100.1 and a peer IP address of 10.10.30.1, and route 2 comes from a neighbor with a router ID of 10.10.200.1 and a peer IP address of 10.10.50.1. Both routes have the same MED value, origin value, AS path length, and local preference number.
In this scenario, which statement is correct about the active route?

• A.Route 1 will be active because of the peer IP address.
• B.Route 2 will be active because of the peer IP address.
• C.Route 1 will be active because of the router ID.
• D.Route 2 will be active because of the router ID.

Comment: *

Name: *

Email: *

Verification: *

You want to provide Layer 2 connectivity between campus sites using Ethernet switches through a metro Ethernet service provider who is using Q-in-Q tagging on their network.
Referring to the exhibit, what are two design considerations in this environment? (Choose two.)

• A.VXLAN could be implemented on your network across this service provider network.
• B.Each campus switch shown must have a C-Tag 300 configured.
• C.L2PT is required on the SP network to support the spanning tree protocol.
• D.Each campus switch shown must have S-Tag 300 configured.

Comment: *

Name: *

Email: *

Verification: *

You are implementing 802.1x access control in your network of EX Series switches. You have some older client devices connecting to your network which do not support 802.1x.
Which statement is true regarding the older devices?

• A.By default, the supplicant will send EAP messages and keep the port in an unauthorized state.
• B.By default, the authenticator will send EAP messages and keep the port in an unauthorized state.
• C.By default, the authenticator will send EAP messages until it reaches a predefined, after which it begins to forward traffic.
• D.By default, the supplicant will send EAP messages until it reaches a predefined limit, after which it begins to forward traffic.

Comment: *

Name: *

Email: *

Verification: *

You have multiple BGP routes to the same prefix with equal local-preference values and AS-path lengths.
In this scenario, which route will be preferred in the route selection process?

• A.The route with the least preferred origin value.
• B.The route with the lowest MED value.
• C.The route with the most preferred origin value.
• D.The route with the highest MED value.

Comment: *

Name: *

Email: *

Verification: *