You are troubleshooting a BGP connection.
Referring to the exhibit, which two statements are correct? (Choose two.)

• A.The 192.168.1.5 peer has a misconfigured MD5 key.
• B.Packet fragmentation is preventing the session from establishing.
• C.The ge-0/0/1 interface is disabled.
• D.The 192.168.1.4 peer has a misconfigured autonomous system number.

Comment: *

Name: *

Email: *

Verification: *

You are asked to deploy 802.1X on your EX Series switches. You need to ensure authenticated devices continue to have access to the network even if the authentication server fails.
Which action meets this configuration objective?

• A.Configure the server fail fallback with a value of sustain.
• B.Set the reauthentication interval to a value of 0.
• C.Configure the static MAC bypass for the authentication server.
• D.Set the reauthentication interval to a value of disable.

Comment: *

Name: *

Email: *

Verification: *

You have applied the CoS configuration shown in the exhibit to an EX4300 switch.
Which two statements are true? (Choose two.)

• A.All strict-high priority queues are serviced in a round-robin fashion as long as they have remaining credits
• B.All strict-high priority queues are serviced in a round-robin fashion regardless of available credits.
• C.Packets in low priority queues transmit only when start-high priority queues are empty
• D.Packets in low priority queues are serviced when strict-high priority queues have no available credits

Comment: *

Name: *

Email: *

Verification: *

Remote branches connect to the corporate WAN through access switches. The access switches connect to access ports on the WAN distribution switch, as shown in the exhibit. L2PT has previously been configured on the tunnel Layer 2 traffic across the WAN. You decide to move the L2PT tunnel endpoints to the access switches. When you apply the L2PT configuration to the access switches, the ports that connect the access switches to the distribution switch shut down.
Which action would solve this problem?

• A.Configure the links between the access switches and the distribution switch as a trunk port.
• B.Configure a GRE tunnel to encapsulate the L2PT traffic across the WAN.
• C.Disable the BPDU block function on the access switches.
• D.Disable the BPDU block function on the distribution switch.

Comment: *

Name: *

Email: *

Verification: *

You are troubleshooting an OSPF adjacency issue between R1 and R2.

What is the reason for the ExStart state shown in the exhibit?

• A.The MTU is not the default on R1 and R2.
• B.R2 was elected as the designated router.
• C.R1 was elected as the backup designated router.
• D.R1 and R2 are using the same IP address.

Comment: *

Name: *

Email: *

Verification: *