You are designing a Layer 3 fabric underlay using EBGP. You will implement an E VPN-signaled VXLAN
overlay on the Layer 3 fabric.
In this scenario, what must you do in the underlay to ensure that the VXLAN overlay will be able to function
properly?

• A.The underlay should support the PIM protocol
• B.Each device in the underlay should advertise its loopback address
• C.The underlay should advertise the host connected interlaces on all leaf device
• D.The underlay should be configured with a separate VRF tor each potential tenant

Comment: *

Name: *

Email: *

Verification: *

You want to configure redundant Layer 3 gateways
In this scenario, which two juniper best practices would accomplish this task? (Choose two.)

• A.Configuring both IRB interfaces manually with the same IP address
• B.Allowing Junos to dynamically create the virtual IP address of the IRB interface
• C.Configuring both IRB interfaces manually with the same address
• D.Allowing Junos to dynamically create the virtual MAC address of the IRB interface

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1's VRF-1 to its INSPECT-VRF. however, the traffic is not reaching service L2.
Referring to the exhibit, which two steps should you take to troubleshoot the problem? (choose two.)

• A.Ensure that VRF-1 and INSPECT-VRF route targets on L1 and L2 match.
• B.Examine the INSPECT-VRF.inet. 0 route table on L1 for a default route that will direct the traffic to L2.
• C.Ensure that the route target in the INSPECT-VRF of L1 matches the route target of the INSPECT-VRF of L2.
• D.Examine the INSPECT-VRF.evpn 0 route table on L1 for a default route that will direct the traffic to L2.

Comment: *

Name: *

Email: *

Verification: *

You are configuring an MX Series router to act as a Layer 3 gateway to route traffic between VXLANs in different data centers across a WAN connection. In this scenario, what must you do to enable this communication?

• A.Configure route reflectors.
• B.Change the UDP port used by the VXLANs.
• C.Configure the IRB interfaces to connect the VXLANs.
• D.Enable PIM on all interfaces.

Comment: *

Name: *

Email: *

Verification: *

Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down. Referring to the exhibit, which statement is correct?

• A.Type-1 routes for each VM will be withdrawn one at a time.
• B.Type-1 routes for all VMs in the site will expire all at once.
• C.Type-1 routes for all VMs in the site will be withdrawn all at once.
• D.Type-1 routes for each VM will expire one at a time.

Comment: *

Name: *

Email: *

Verification: *