Polymerization is the process of:

• A.Monomers joining together
• B.All thermoplastic coatings
• C.All organic coatings
• D.Monomers telegraphing

Comment: *

Name: *

Email: *

Verification: *

Checking is

• A.a very small hole in a coating caused when air or solvent is trapped in porous film and then escapes.
• B.an exposed area of the substrate or previous coat material, caused by poor application technique.
• C.surface breaks in the film that often result from grease or oil contamination and revel the substrate.
• D.a fine crack in the surface of a coating that rarely reaches the substrate

Comment: *

Name: *

Email: *

Verification: *

An inspectors personal log book should contain:

• A.No comments regarding the application team
• B.Objective comments regarding the application work
• C.The inspector's personal opinions of the application team
• D.Subjective comments re ding the application team

Comment: *

Name: *

Email: *

Verification: *

You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3.
Could this have any impact on the final surface preparation appearance?

• A.Yes, because the 'two standards are not equivalent
• B.It depends on which hand tool the Contractor selects
• C.No, because there is no real difference in the standards
• D.It depends on which power tool the Contractor selects

Comment: *

Name: *

Email: *

Verification: *

When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

• A.A method to grade surface profile
• B.A general guide
• C.A final conflict resolution method
• D.Pass/fail criteria

Comment: *

Name: *

Email: *

Verification: *