A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

• A.5 to 6 mils (125 to 150 microns)
• B.6 to 7 mils (150 to 175 microns)
• C.8 to 10 mils (200 to 250 microns)
• D.10 to 12 mils (250 to 300 microns)

Comment: *

Name: *

Email: *

Verification: *

Daily reports are important because:
Select All That Apply

• A.The information aids communication with supervisors.
• B.Management uses them to make personnel decisions.
• C.Inspectors rarely change on a project.
• D.the information impacts future projects.

Comment: *

Name: *

Email: *

Verification: *

The NACE Inspector should perform tests for soluble salts:

• A.Prior to surface preparation
• B.After surface preparation
• C.When specified
• D.Prior to coating application

Comment: *

Name: *

Email: *

Verification: *

The least effective method of surface cleaning is most likely

• A.hand tool cleaning.
• B.power tool cleaning.
• C.water blasting.
• D.dry grit blasting.

Comment: *

Name: *

Email: *

Verification: *

When using the ISO comparator in accordance with ISO 8503, if the surface profile does not directly compare to one of the four segments the inspector should:

• A.Use another method as the comparator method is too subjective
• B.Record the segment with the less aggressive profile
• C.Record your result by identifying two segments
• D.Record the segment with the more aggressive profile

Comment: *

Name: *

Email: *

Verification: *