A customer is showing disk utilization is at 100% in Active IQ even though there are low protocol operations on the controller. You review the data shown in the exhibit.

In this situation, what should you do?

• A.Replace disk 6b.39.
• B.Reseat shelf module B.
• C.Replace disks 6b.34 and 6a.19.
• D.Add disks to the aggregate to bring down the average utilization.

Comment: *

Name: *

Email: *

Verification: *

Your storage system has experienced a double-disk failure. When is this scenario considered to be in double-degraded mode?

• A.when two disks failed on a single disk shelf
• B.when two disks failed on a node
• C.when two disks failed in a single RAID group
• D.when two disks failed on a single aggregate

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit.


Your customer's MetroCluster controllers have generated AutoSupport notifications with a "DISK REDUNDANCY FAILED" message.
Referring to the exhibit, which component is causing the problem?

• A.the ATTO bridges on site3
• B.the SAN switch site3_3
• C.the SAN switch sitel_2
• D.the inter-switch link (ISL) between site1 and site3

Comment: *

Name: *

Email: *

Verification: *

You have a 4-node MetroCluster system. A node needs to be taken down for maintenance, but all data needs to remain online.
In this scenario, what should you do to bring down a single node?

• A.Perform an aggregate relocation of the CFO aggregates on the node.
• B.Perform an HA takeover of the node.
• C.Perform a MetroCluster switchover.
• D.Disable HA on each side of the MetroCluster.

Comment: *

Name: *

Email: *

Verification: *

Your customer is concerned about SnapMirror transfers consuming too much network bandwidth. In this situation, which two SnapMirror features would help the customer? (Choose two.)

• A.throttling
• B.network compression
• C.fan-out
• D.fan-in

Comment: *

Name: *

Email: *

Verification: *