The system assigns an active inspection type during inspection lot creation Where can the system choose the inspection type? Note : 3 correct answer
Correct Answer: A,B,E
Question 37
Your customer wants to add the quality score of a material as criterion for the vendor evaluation Where do you set the calculation procedure for the quality score:?
Correct Answer: B
Question 38
Which settings are required for the immediate creation of inspection instruction during goods receipt process. Note : 3 correct answer
Correct Answer: A,D,E
Question 39
Which dynamic modification levels can be set in the inspection plan? Note: There are 3 correct answers to this question.
Correct Answer: A,C,D
Dynamic modification levels in SAP QM determine the granularity at which inspection scope changes (e.g., reduced to full inspection) are applied in an inspection plan (transaction QP01): * Characteristic Level (A): Modification can occur at the individual characteristic level within an operation, allowing specific MICs to skip or intensify based on their quality history. * Inspection Lot Level (C): The entire inspection lot can be modified (e.g., skipped), based on the quality level for the material or combination (e.g., material/supplier). * Operation Level (D): Modification can apply to an operation, adjusting all characteristics within it based on performance (e.g., operation-specific skip). * Inspection Type Level (B): Inspection types define the process (e.g., 01 for GR), but dynamic modification is not set at this level; it's tied to plans or lots. * Work Center (E): Work centers are execution locations, not a level for dynamic modification in QM. Thus, "Characteristic level," "Inspection lot level," and "Operation level" are the correct answers.References: SAP Help Portal - "Dynamic Modification in Inspection Planning"; SAP S/4HANA QM Customizing Guide - "Dynamic Modification".
Question 40
Which inspection origin creates only unplanned physical samples?
