Refer to the exhibit. A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology.
Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?

• A.Option C
• B.Option B
• C.Option A
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer working for a private telecommunication company with an employee id 3977 74 814 implemented the configuration on Router 1. what is the effect of it?

• A.Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
• B.Router 1 sends up to three paths to neighbor 192.168.1.1 for all routes
• C.Router 1 sends only one best path to neighbor 192 168.1.1.
• D.Router 1 receives only one best path from neighbor 192.168.1.1

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer working for a private telecommunication company with an employee id 3977 74 814 implemented the configuration on Router 1. what is the effect of it?

• A.Router 1 sends only one best path to neighbor 192 168.1.1.
• B.Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
• C.Router 1 sends up to three paths to neighbor 192.168.1.1 for all routes
• D.Router 1 receives only one best path from neighbor 192.168.1.1

Comment: *

Name: *

Email: *

Verification: *

Refer io the exhibit. While applying the configurations on two routers an engineer notices that OSPF adjacency Between them remains down. Through the ping test the engineer confirmed that both me routers have Layer 3 reachability between them. Which action should me engineer take to make the adjacencies to full?

• A.Delete the area 0 authentication message-digest command from the OSPF process in R2
• B.Enter the command ip ospf authentication in R2 interface
• C.Enable OSPF just inside the router OSPF process not in the interfaces of any router
• D.Delete the area 0 authentication message-digest command from the OSPF process in R1

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Routers R1, R2, R3, and R4 have been configured to run OSPF, and router R5 is running EIGRP. Traffic from R1 to R5 is expected to pass via R4, but OSPF routing has calculated the best path R3. Which action corrects the problem?

• A.Change the metric-type value on R3 to 2.
• B.Reconfigure R1 in Area 0.
• C.Configure R1 with a static route to the R5 networks and set R5 as the next hop.
• D.Configure R3 to use metric-type 1 with a higher metric than R4.

Comment: *

Name: *

Email: *

Verification: *