Refer to the exhibit. IS-IS is the IGP for the network, where routers R1, R2, R3, and R4 are Level
1 routers in Area 12 and routers R5 and R6 are Level 2 routers in area 16. According to the network design, router R1 must send traffic to R6 using R4 as its next hop. To meet the requirement, a network engineer configured route filtering on R2 to prevent the route to R6 from being advertised from R2. However, R1 is still using R2 as the next hop. Which action must the engineer take to resolve the issue?

• A.Configure routers R5 and R6 as Level 1/2 routers.
• B.Move all routers into the same IS-IS area.
• C.Disable wide area metrics and use only cost to perform the route manipulation.
• D.Manipulate link costs to provide the desired routing through R4.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network operator must stop 10.33.33.33/32 from being redistributed into Level 1 router XR1. Which configuration meets this need?

• A.
• B.
• C.
• D.

Comment: *

Name: *

Email: *

Verification: *

Refer io the exhibit.

While applying the configurations on two routers an engineer notices that OSPF adjacency Between them remains down Through the ping test the engineer confirmed that both me routers have Layer 3 reachability between them Which action should me engineer take to make the adjacencies to full?

• A.Enable OSPF just inside the router OSPF process not in the interfaces of any router
• B.Delete the area 0 authentication message-digest command from the OSPF process in R2
• C.Delete the area 0 authentication message-digest command from the OSPF process in R1
• D.Enter the command ip ospf authentication in R2 interface

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Routers R1 and R2 reside in AS 65530, which is multihomed to the Internet.
A network engineer expects devices in the AS to use R2 to access the Internet, but they are using R1 as the exit point from the AS. Which action corrects the problem?

• A.Add a sequence number to the route map to remove the implicit deny.
• B.Change the route map direction in the neighbor statement to out.
• C.Configure the route map with a local preference of 200 or higher.
• D.Remove the neighbor statements from the address family configuration and activate the neighbor globally on R1.

Comment: *

Name: *

Email: *

Verification: *