Refer to the exhibit.

If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)

• A.CE1 is supporting CSC.
• B.The PE-CE routes between the devices are being exchanged by OSPF
• C.PE1 labels the routes it learns from CE1 with the route-target 222:2 and shares them with its VPNv4 peers.
• D.CE1 must use OSPF to establish a neighbor relationship with PE1.
• E.PE1 labels the routes it learns from CE1 with the route-target 111:1 and shares them with its VPNv4 peers.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network engineer has been called to configure the four PE devices in order to enable full communication among the four CE devices connected to them. While starting to configure, he experienced a connectivity issue. Which two tasks should the engineer perform in order to begin the process correctly? (Choose two.)

• A.Configure PE4 to import route-targets 101:1 and 202:2.
• B.Configure PE3 to import route-targets 100:1 and 200:2.
• C.Configure PE3 to export route-targets 100:1 and 200:2.
• D.Configure PE1 to import route-targets 300:3 and 400:4.
• E.Configure PE2 to export route-targets 300:3 and 400:4.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is implementing an MPLS P2MP TE solution. Which type of router can serve as the midpoint router and the tailend router in this P2MP TE network implementation?

• A.headend
• B.source
• C.transit
• D.bud

Comment: *

Name: *

Email: *

Verification: *

What is the effect of this configuration?

• A.An LSP virtual interface tunnel is created.
• B.Router 1 accepts multicast routes with a tag of 12:1
• C.The mroute table is cleared.
• D.A Cisco MPLS TE tunnel is generated with 192.168.1.2 as the source IP address of router 1.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?

• A.A system notification is sent to the network administrator that triggers the manual configuration of the new MAC address on PE2 and PE3.
• B.The new MAC address is sent by BGP to PE2 and PE3 as a Type 2 BGP route.
• C.The MAC address is entered into the CAM table and is classified for use on the native VLAN
• D.The MAC address is entered into the CAM table only if it is learned on the native VLAN.

Comment: *

Name: *

Email: *

Verification: *