Cisco Unified Computing System Manager raises a critical error message that indicates that the system has overlapping Ethernet and FCoE VLANs. All of the Ethernet traffic on the overlapping VLANs drops. Which action resolves the issue?

• A.Modify the VLAN assignment to vNICs.
• B.Change the PIN groups on the vHBAs.
• C.Modify the FCoE VLAN.
• D.Set the FCoE VLAN as the native VLAN on server uplinks.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An OSPF adjacency between Router-A and Router-B fails to reach the FULL state. Which action resolves the issue?

• A.Adjust the MTU on Router-A to 1600.
• B.Disable the check of the MTU value.
• C.Set the OSPF media type to point-to-point.
• D.Adjust the MTU on Router-B to 1604.

Comment: *

Name: *

Email: *

Verification: *

A system administrator adds two vNICs to an existing service profile that is used to run a vSphere environment to support disjoint Layer 2 network connectivity. However, after the server is rebooted, the host is not accessible on the network Which action resolves the issue?

• A.Build a new service profile with the desired network configuration
• B.Add the disjoint Layer 2 VLANs to an existing vNIC rather than adding new vNICs
• C.Remove all existing vNICs and add them in the desired order.
• D.Create a vNIC placement policy to avoid adapter renumbering

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Partial configuration from N9K-1 and N9K-2 is included. The client has two WANs connected.
* WAN-1 is for normal business-day activities.
* WAN-2 is for server backups during nonworking hours of 1:00 a.m. to 5:00 a.m. daily.
The client says that at the scheduled time for backup, the data center server failed to use the WAN-2 link to back up the servers to the cloud backup system. What is the solution to this problem?

• A.The event timer must be written in epoch time format.
• B.The Cisco Nexus switch must be configured with one applet because a configuration with two applets will fail.
• C.The Cron entry must be configured without double quotes.
• D.The applet called "Backup" must include an action to remove the current static route.

Comment: *

Name: *

Email: *

Verification: *

A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager Which set of steps resolves the issue?

• A.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
  2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
  3) Check for runtime link down status.
  4) Reseat the affected IOM.
• B.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
  2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
  3) Check for runtime link down status
  4) Reseat the affected IOM.
• C.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
  2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
  3) Check for runtime link down status
  4) Reseat the affected IOM.
• D.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
  2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
  3) Check for runtime link down status.
  4) Reseat the affected IOM.

Comment: *

Name: *

Email: *

Verification: *