What does this adapter output indicate?
adapter 1/6/1 (fls): 2# lunlist 9
vnic: 9 lifid: 6
- FLOGI State : flogi est (fc_id Oxac0e04)
- PLOGI Sessions
- WWNN 50:0a:09:83:8d:53:43:44 WWPN 50:0a:09:83:8d:53:43:44 fc_id 0x000000
- LUN ' s configured (SCSI Type, Version, Vendor, Serial No.)
- LUN ID: Ox0000000000000000 access failure
-REPORT LUNs Query Response
- Nameserver Query Response
-WWPN: 54:b1:6a:94:64:3e:73:44

• A.The configured initiator LUN ID does not match the configured target LUN ID
• B.The target device configuration does not allow the initiator to access the LUN
• C.The port types between the target and initiator are incorrectly configured
• D.The target of the configured zone does not match the target of the configured boot order

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. The expected routes are not being leaked as expected from VRF RED to VRF BLUE. Which action resolves the issue?

• A.Configure VRF BLUE under the BGP configuration.
• B.Change the route targets under the VRFs.
• C.Set the community to 65000:65000 under the route map.
• D.Include the "le 32" knob under the RED_TO_BLUE_ACL prefix list.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer is configuring the FCoE N_Port virtualization storage area network.
After the initial implementation, server 11 fails to connect to the disk array. Which action resolves the issue?

• A.On N9K interface vfc11 and MDS interface vfc 1/1, change switchport mode configuration to E
• B.On N9K interface vfc11, change switchport mode configuration to NP
• C.On MDS interface vfc 1/1, change switchport mode configuration to VF
• D.On N9K interface vfc11 and MDS interface vfc 1/1, change switchport mode configuration to F

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer deploys a SAN environment with two interconnected Cisco MDS 9000 Series Switches. When the engineer attempts a zone merge, it fails with the error that is presented in the exhibit.
Which action resolves the issue?

• A.Import or export a zone set between the switches to synchronize the switches.
• B.Change the name of one of the zones to match the other zone set.
• C.Ensure that the zone members have different names.
• D.Set the distribute policy of the zone to full.

Comment: *

Name: *

Email: *

Verification: *

An engineer troubleshoots a failed DCBX exchange between a server and a Cisco Nexus switch. Which action allows DCBX to successfully negotiate?

• A.Enable ETS.
• B.Enable PFC.
• C.Enable Cisco Discovery Protocol.
• D.Enable LLDP.

Comment: *

Name: *

Email: *

Verification: *