Refer to the exhibit The EEM applet must generate a syslog message whena BGP adjacency flaps. This message must be displayed to the console of the switch. However, when a BGP adjacency failure is simulated, no syslog message is displayed. Which action resolves the issue?

• A.Add the event-default action statement.
• B.Modify the policy to use the snmp trap action.
• C.Adjust the policy to match an SNMP OID.
• D.Set the logging priority to Wamings.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer creates an EEM script to trigger an SNMP notification when a user enters configuration mode, but the trap is not received when the condition is met. Which action resolves the issue?

• A.Append action 2.0 event-default to the script
• B.Append action 2.0 cli "conf t" to the script
• C.Modify snmp-trap strdata "Configuration changed" to syslog msg Configuration changed
• D.Modify cli match "conf t" to "snmp match "conf t"

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is troubleshooting the connectivity between Server-1 and Server-2. Which action resolves the connectivity issue?

• A.Enable BGP advertise pip feature on both leaf switches
• B.Configure the same source IP address on NVE and virtual peer link on leaf switches
• C.Change all ports on spine switches as port-type fabric
• D.Classify CFS messages for strict priority queue on spine switches

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. The HSRP configuration in the exhibit fails to function. Which action resolves this issue?

• A.Enable IP redirects.
• B.Set the MTU to 1500 bytes.
• C.Configure HSRP version 2.
• D.Configure the same HSRP group on both devices.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Interface fc1/5 is offline. Which action should be taken to troubleshoot the issue?

• A.Activate the correct zoneset for VSAN 100.
• B.Update the FLOGI database to contain the FLOGI entries for interface fc1/5 in VSAN 100.
• C.Update the FCNs database to contain names for VSAN 100.
• D.Configure the upstream ports and the server ports to be in VSAN 100.

Comment: *

Name: *

Email: *

Verification: *