Which diagnostic command can you use to show the SD-WAN rules interface information and state?

• A.diagnose sys virtual-wan-link service
• B.diagnose sys virtual-wan-link neighbor.
• C.diagnose sys virtual-wan-link member.
• D.diagnose sys virtual-wan-link route-tag-list

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What must you configure to enable ADVPN?

• A.The protected subnets should be set to address object to all (0.0 .0. o/o).
• B.Each VPN device has a unique pre-shared key configured separately on phase one
• C.On the hub VPN, only the device needs additional phase one sett
• D.ADVPN should only be enabled on unmanaged FortiGate devices.

Comment: *

Name: *

Email: *

Verification: *

Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )

• A.FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
• B.FEC transmits additional packets as redundant data to the remote device.
• C.FEC transmits the original payload in full to recover the error in transmission.
• D.FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
• E.FEC is useful to increase speed at which traffic is routed through IPsec tunnels.

Comment: *

Name: *

Email: *

Verification: *

What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

• A.Interface-based shaping mode
• B.Shared policy shaping mode
• C.Reverse policy shaping mode
• D.Per-IP shaping mode

Comment: *

Name: *

Email: *

Verification: *

What is the lnkmtd process responsible for?

• A.Monitoring links for any bandwidth saturation
• B.Logging interface quality information
• C.Flushing route tags addresses
• D.Processing performance SLA probes

Comment: *

Name: *

Email: *

Verification: *