Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

• A.The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
• B.Check interval is the time to wait before a packet sent by a member interface considered as lost.
• C.Port2 needs to wait 500 milliseconds to change the status from alive to dead.
• D.The dead member interface stays unavailable until an administrator manually brings the interface back.

Comment: *

Name: *

Email: *

Verification: *

Refer to exhibits.


Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?

• A.The SLA state of port1 is dead after five unanswered requests by the SLA servers.
• B.SD-WAN member interfaces are affected by the SLA state of the inactive interface.
• C.Port1 became dead because no traffic was offload through the egress of port1.
• D.Both SD-WAN member interfaces have used separate SLA targets.

Comment: *

Name: *

Email: *

Verification: *

What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)

• A.It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
• B.It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
• C.It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
• D.It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

Comment: *

Name: *

Email: *

Verification: *

Refer to exhibits.


Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

• A.The guaranteed-10mbps option must be selected as the reverse shaper option.
• B.The reverse shaper option must be enabled and a traffic shaper must be selected
• C.The guaranteed-10mbps option must be selected as the per-IP shaper option
• D.A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

Comment: *

Name: *

Email: *

Verification: *

Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?

• A.The 10 Mbps bandwidth is shared equally among the IP addresses.
• B.Each IP is guaranteed a minimum 10 Mbps of bandwidth.
• C.FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
• D.A single user uses the allocated bandwidth divided by total number of users.

Comment: *

Name: *

Email: *

Verification: *