As shown in figure, Clent1, C lent2 and Clent3 are simultaneously clients of RR1. Ri introduces 10 routes. It is assumed that the RGP is configured correctly. The neighbor relationship has been established, how many route entries exist in the BGP routing table of the most clIient3?
Refer to the following command output on the router R1. Which of the following statements is incorrect?
<R1> display interface Tunnel
Tunnel0/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 15:21:23 UTC-08:00
Description: ! 0.0.3.3
Route Port, The Maximum Transmit Unit is 1500
Internet Address is 20.1.1.1/24
Encapsulation is TUNNEL, loopback not set
Tunnel source 10.0.1.1 (LoopBack0), destination 10.0.3.3
Tunnel protocol/transport GRE/IP, key disabled
keepalive disabled
Checksumming of packets disabled
Current system time: 15:21:37-08:00
300 seconds input rate 0 bits/sec, 0 packets/sec
300 seconds output rate 0 bits/sec, 0 packets/sec
13 seconds input rate 0 bits/sec, 0 packets/sec
13 seconds output rate 448 bits/sec, 0 packets/sec
9 packets output, 824 bytes
0 output error
Input bandwidth utilization : -
Output bandwidth utilization : -
In DU label advertisement mode, if the liberal label retention mode is used, the device reserves labels received from all the LDP peers regardless of whether the LDP peer is the optimal next hop for reaching the destination network.
For telemetry data push, data can be transferred between devices and collectors using the TLS protocol. TLS must be configured for data encryption if data is pushed based on gRPC.
BGP4+ is running between two routers, and the neighbor relationship is normal, but the BGP routing table of the router on this side does not have a neighbor route entry.
Enter your email address to download Huawei.H12-891_V1.0.v2026-06-05.q295 Dumps
