When redistributing IGP routes into BGP. what information .s used by default on Junos platforms to determine the BGP route's MED attribute value?

• A.route protocol source
• B.routing information base
• C.the IGP Metric
• D.the IGP route preference

Comment: *

Name: *

Email: *

Verification: *

You are asked to configure an 802.1X solution that supports dynamic VLAN assignment.
In this scenario, which two modes support using vendor-specific attributes (VSAs)? (Choose two.)

• A.static MAC bypass mode
• B.single-secure supplicant mode
• C.multiple supplicant mode
• D.single supplicant mode

Comment: *

Name: *

Email: *

Verification: *

You ate deploying P|M source-specific multicast (SSM) for a new multicast messaging service You have configured the multicast source to use 236.44.123.100 as the multicast address. You are not able to join the PIM SSM multicast teed Which two solutions would resolve this problem? (Choose two )

• A.Reconfigure the multicast source to use an address in the range of 224.0.0 0 through
  224.255.255.255.
• B.Add the multicast address to the (edit routing-options multicast ssm-map) stanza.
• C.Reconfigure the multicast source to use an address in the range of 232 0.0 0 through
  232.255.255.255
• D.Add the multicast address to the [edit routing-options multicast ssm-groups] stanza.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

You have configured and applied the policer shown in the exhibit to your Junos device.
Which statement is true in this scenario?

• A.Traffic exceeding the committed-burst size will be marked with a loss priority of high.
• B.Traffic exceeding the excess-burst size will be discarded.
• C.Traffic exceeding the committed-information-rate will be rate limited.
• D.Traffic exceeding the committed-burst size will be discarded.

Comment: *

Name: *

Email: *

Verification: *

A customer requires that the switch responds to an ARP request only if the source and target IP address are on different subnets.

Referring to the Exhibit, how would you accomplish this task?

• A.Enable the no-gratuitous-arp request command under the interface hierarchy.
• B.Change the proxy ARP parameter setting to restricted.
• C.Create a static ARP entry for the host.
• D.Remove the proxy ARP setting and clear the entry.

Comment: *

Name: *

Email: *

Verification: *