After expanding a two-node AFF A300 cluster with two AFF A700 nodes, you observe latencies when data is accessed indirectly. The system node run -node -command netstat command shows retransmits and packet drops on the LIFs. The AFF A700 nodes with 40 Gbps and the AFF A300 connect with 10 Gbps to the cluster interconnect. You are using Cisco Nexus 3132Q cluster interconnect switches. You just updated to ONTAP 9.8 software.
In this scenario, what is causing this problem?

• A.The 10 Gbps to 10 Gbps cluster Interconnect is creating a speed mismatch.
• B.AFF A300 and AFF A700 node mixing Is not supported in ONTAP 9.8 software.
• C.The AFF A300 Is using an adapter card for the cluster Interconnect, but only onboard ports are supported.
• D.There is an NXOS firmware mismatch, verify in the Interoperability Matrix (1MTJ for a supported version.

Comment: *

Name: *

Email: *

Verification: *

A customer calls you to troubleshoot a network issue. The customer wants to create a packet trace for allclients
on the 192.168.9.0/24 subnet.

Referring to the exhibit, on which interface do you have to run the packet trace?

• A.e2a-100
• B.e2a-1092
• C.a0a-322
• D.a0a-456

Comment: *

Name: *

Email: *

Verification: *

Your customer is running a NetApp AFF A800 system with NetAppONTAP 9.8 software and states that their
NS224 shelf is not showing with the correct shelf ID. You analyze the data and the shelf shows an
identification of "1.SHFHUXXXXXXXXXX."
What is the cause of the reported Issue?

• A.The shelf was cabled Incorrectly.
• B.The shelf had a disk replaced too quickly.
• C.The shelf has been power cycled.
• D.A new shelf was added to the controller.

Comment: *

Name: *

Email: *

Verification: *

A customer with an FC MetroClusterconfiguration that is running NetApp ONTAP 9.8 software experienced a
site outage and wants to know why the MetroClusler configuration did not switch over to the other site.
What are two reasons for this problem? (Choose two.)

• A.An ISL link was not operating at 16Gbps.
• B.The site had unmirrored aggregates.
• C.The ISLs were down between the sites.
• D.There was a failed PSU inthe switchover site.

Comment: *

Name: *

Email: *

Verification: *

A customer with an FC MetroCluster configuration that is running NetApp ONTAP 9.8 software experienced a site outage and wants to know why the MetroClusler configuration did not switch over to the other site.
What are two reasons for this problem? (Choose two.)

• A.There was a failed PSU in the switchover site.
• B.The ISLs were down between the sites.
• C.The site had unmirrored aggregates.
• D.An ISL link was not operating at 16Gbps.

Comment: *

Name: *

Email: *

Verification: *