What happens when the command diskcopy is run from nodeshell?

• A.It pre-fails a drive in an aggregate and copies it to a spare.
• B.It performs a low-level copy of the disk to another disk.
• C.It copies the disk content to a specified volume.
• D.It triggers a RAID reconstruction of that disk.

Comment: *

Name: *

Email: *

Verification: *

While performing a health check on a cluster, you notice the following entries in the cluster event log:

Referring to the exhibit, which of the following actions do you take?

• A.Sanitize the disk.
• B.Reseat the disk.
• C.Review the current firmware and known issues.
• D.Use diskcopy to copy the disk to a working spare.

Comment: *

Name: *

Email: *

Verification: *

You are replacing a boot device on a FAS8300 system that is running ONTAP 9.10P6 software.
You attach a USB memory stick to the external USB port on the storage controller but cannot access the memory stick. What step needs to be performed to access the boot device?

• A.Set the port to "enabled" with setenv.
• B.You need to use ONTAP 9.11 or later software.
• C.Add the boot device before the BIOS is loaded.
• D.The external USB port is not activated on NetApp systems.

Comment: *

Name: *

Email: *

Verification: *

Users are reporting slowness when accessing certain volumes with extremely high-performance requirements via NFSv3 on a four-node switched NetApp ONTAP cluster. Other volumes on the same cluster are behaving normally. Investigation reveals that there is a high amount of throughput recorded for the cluster LIFs. What action enables you to determine which volumes are affected?

• A.View the active CIFS sessions on the cluster to determine the affected workloads.
• B.Check the NFS file locking lease period for the affected volumes.
• C.Review NFS export policies to ensure that client subnets are listed for the affected volumes.
• D.View the NFS connected client information and review the "Remote-Reqs" counter.

Comment: *

Name: *

Email: *

Verification: *

During power on, a memory error is diagnosed, and the system fails to boot NetApp ONTAP software. As AutoSupport is not enabled, a part must be requested from NetApp Support. What action do you take to address this issue?

• A.Use NetApp Active IQ to drill down on the issue.
• B.Open a case through https://support.netapp.com.
• C.Log into NetApp ONTAP System Manager to gather details.
• D.Boot into diagnostics mode.

Comment: *

Name: *

Email: *

Verification: *