You are reviewing the output of disk show and one of the disks is reporting a container type of
"unknown". What is causing this status?

• A.The disk is not owned by a member of the high-availability (HA) pair.
• B.The disk is failed.
• C.The disk is in the maintenance center.
• D.The disk does not have an owner.

Comment: *

Name: *

Email: *

Verification: *

At what stage is a write acknowledged to a client?

• A.when the write is present in the NVRAM on the local node and its HA partner
• B.when the write has been flushed from NVRAM to RAM
• C.when the write has been flushed to disk
• D.when the write is present in the local node RAM and NVRAM

Comment: *

Name: *

Email: *

Verification: *

A node has unexpectedly failed and is unresponsive through its node management interface.
Which two commands from the Service Processor are helpful to determine the root cause?
(Choose two.)

• A.sp status -d
• B.event log show
• C.system log
• D.system core

Comment: *

Name: *

Email: *

Verification: *

Which two scenarios are common causes of the root volume needing root volume recovery?
(Choose two.)

• A.The root volume ran out of space.
• B.The mainboard was replaced following a Non-Maskable Interrupt (NMI) panic.
• C.Root volume migrate was performed.
• D.The cluster configuration is out of sync on the volume.

Comment: *

Name: *

Email: *

Verification: *

You have just completed a controller swap on your cluster. At the end of the process, you are directed to verify the storage using the debug vreport showcommand.
You run the command and see the following output:

Based on the output, which action do you take?

• A.Use the debug vreport fix -type aggregate command.
• B.Use the storage aggregate remove-stale-record command.
• C.Use the storage transition aggregates start command (the fix recommendation).
• D.Use the storage aggregate delete command.

Comment: *

Name: *

Email: *

Verification: *