Which two statements are correct about East-West Malware Prevention? (Choose two.)

• A.A SVM is deployed on every ESXi host.
• B.NSX Application Platform must have Internet access.
• C.An agent must be installed on every ESXi host.
• D.An agent must be installed on every NSX Edge node.
• E.NSX Edge nodes must have Internet access.

Comment: *

Name: *

Email: *

Verification: *

An administrator has connected two virtual machines on the same overlay segment. Ping between both virtual machines is successful. What type of network boundary does this represent?

• A.Layer 2 VPN
• B.Layer 2 bridge
• C.Layer 2 broadcast domain
• D.Layer 3 route

Comment: *

Name: *

Email: *

Verification: *

Which of the two following characteristics about NAT64 are true? (Choose two.)

• A.NAT64 is stateless and requires gateways to be deployed in active-standby mode.
• B.NAT64 is supported on Tier-1 gateways only.
• C.NAT64 is supported on Tier-0 and Tier-1 gateways.
• D.NAT64 requires the Tier-1 gateway to be configured in active-standby mode.
• E.NAT64 requires the Tier-1 gateway to be configured in active-active mode.

Comment: *

Name: *

Email: *

Verification: *

Which CLI command does an NSX administrator run on the NSX Manager to generate support bundle logs if the NSX UI Is inaccessible?

• A.
• B.
• C.
• D.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.
Which two items must be configured to enable OSPF for the Tler-0 Gateway in the Image? Mark your answers by clicking twice on the image.

Correct Answer:

Explanation
The correct answer is to enable the OSPF toggle and to add an Area Definition for the Tier-0 gateway in the image. These two items are required to configure OSPF on the Tier-0 gateway, as explained in the web search results123.
To mark your answers by clicking twice on the image, you can double-click on the toggle switch next to OSPF to turn it on. The switch should change from gray to blue, indicating that the option is enabled. Then, you can double-click on the Set button next to Area Definition to add an area definition. A pop-up window should appear where you can specify the area ID and type.
1. Click the OSPF toggle to enable OSPF 2. In the Area Definition field, click Set to add an area definition
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.2/administration/GUID-5BEC626C-5312-467D-B8

Comment: *

Name: *

Email: *

Verification: *